Swashplate Settings - Horizon Hobby Spektrum DX8 Guide De Programmation

EN
Rotate the roller to highlight Servo Setup then press the roller to access the Servo
Setup screens. The Travel Adjust screen automatically appears. Use the roller to
access the Reverse option.
Turn roller to highlight channel. Press roller to access channel. Turn roller to
select option. Press roller to accept option.
Highlight the REV NoR Graphic at the bottom of the screen. Press the roller to
select REV or NoR.
Rotate the roller to highlight the channel function. Then press the roller to access
the function. Rotate the roller to select the next channel to reverse, then press the
roller. Repeat this process to complete reversing for all necessary channels.
To Access the Sub-Trim function
In the Servo Setup screen rotate the roller to highlight Travel then press the roller.
Now rotate the roller until Sub-Trim appears, then press the roller to enter the
Sub-Trim function.
Rotate the roller to select the channel then press the roller to select that channel.
Rotate the roller to access the channel you want to adjust then press the roller to
accept that channel.
12
Rotate the roller to highlight the value at the bottom of the screen then press the
roller to access the Sub-Trim Value. Rotate the roller to adjust the Sub-Trim value
for the selected channel. Then press the roller to accept
To Access the Travel function
In the Servo setup function, rotate the roller to highlight Travel then press the
roller to select the function.
Highlight the channel function then press the roller to access the function.
Rotate the roller to select the channel to adjust then press the roller to accept that
channel.
Highlight the values at the bottom of the screen and press the roller to select
them. When you center the corresponding stick both values are highlighted
and adjusted simultaneously. Moving the stick or switch in the desired position
allows you to independently adjust that direction of travel. With the desired value
(s) highlighted rotate the roller to adjust the travel adjust for the selected channel.
Then press the roller to accept the values.
StEP #6

SWASHPlATE SETTINGS

In the Swashplate screen you can adjust the direction and amount of travel for
the aileron, elevator and pitch functions. To achieve the correct travel direction
for Aileron, Elevator and Pitch, first use the reversing function (step #5 above)
to set the servo direction on the aileron, elevator and pitch channels. Set it so
that aileron input on the transmitter' s stick tilts the swashplate right and left, an
elevator input tilts the swashplate tilts forward and backward, and a pitch input
raises and lowers the swashplate.
Then in the Swashplate screen, you can adjust swashplate values positively or
negatively to achieve the overall correct travel direction for aileron, elevator and
pitch. An E-ring function also prevents servo over-travel when simultaneous
extreme aileron and elevator inputs are given. This screen also allows an Expo
function that smoothes out the effect of the servo' s rotation at extreme negative
and positive swashplate values. You should activate the Expo function.
SPEKTRUM DX8 • PROGRAMMING GUIDE