Clearing Jammed Lamination Foil; Trimmer; Selecting The Type Of Cut - GO Europe OLYMPIA A 240 Combo Mode D'emploi

6.1.3

Clearing jammed lamination foil

The device is equipped with an ABS switch (anti-blocking sliding switch) to
clear foil jams quickly.
Proceed as follows if the lamination foil jams:
1. Switch the device off: Set the On/Off switch to OFF.
2. Slide the ABS switch fully to the left.
3. Hold the laminator firmly and pull the lamination foil together with the
document to be laminated out of the laminator's infeed.
4. Slide the ABS switch fully to the right.
5. Clean the transport rollers of any deposits and residual adhesive by
inserting a folded piece of paper in the laminator infeed, refer to Chapter
"Cleaning the transport rollers".
Note: If foil jams occur repeatedly or jammed foil cannot be removed
from the laminator, please contact our hotline (refer to Guarantee).
33 33
6.2

Trimmer

The trimmer can be used to cut paper, card, photo paper and lamination foil
to size.
6.2.1

Selecting the type of cut

The trimmer is equipped to complete three types of cut:
straight cut,
wave cut,
perforation cut.
Note: The blades are accommodated in protective housing.
Select the type of cut you require, see Fig. 1:
1. Pull the setting lock on the cutting head upwards to the OPEN position.
2. Turn the rotating knob for the cut until the symbol related to the required
cut is at the top.
3. Press the setting lock on the cutting head downwards to the LOCK
position.
(similar to figure)
Fig. 1
34