THOMSON RK200DABCD Mode D'emploi page 24

DRC (Dynamic Range Control)
Dynamic Range Control (also known as DRC) is a technology used to help make quieter sounds
easier to hear in a noisy environment.
1. In DAB mode, press the [
display "*" to the top right.
2. Press MENU to confirm the setting. The display will return to normal.
DRC OFF - DRC is switched off, broadcast DRC will be ignored.
DRC LOW - DRC level is set to 1/2 that sent by broadcaster.
DRC HIGH - DRC level is used as sent by broadcaster.
Prune (To Remove Stations That are Listed But Unavailable)
In DAB mode, press [
button to select the Prune option.
System (DAB)
In DAB mode, press
to go to the system setting submenu.
1. Language
Press ENTER to go to the language selection; the default source language is English. The
selected language will have "*" displayed at the top right.
Users may choose between "Deutsch", "Italiano" and "Français".
2. Factory Reset
Press ENTER to go to factory reset. If you wish to perform the reset operation, push the
or button until "YES" is highlighted on the display, and press to confirm. A full reset of your
radio will be performed. All presets and station lists will be erased.
3. SW Version
Press ENTER to view the DAB software version. Press Menu or
to normal.
*If there are no operations after 30 seconds, the display will return to normal.
Preset
1. Preset Recall
In DAB mode, press
station stored in preset memory.
Note: If you have not previously stored a preset station and the preset button is pressed,
"Empty Preset" will be displayed.
2. Saving Presets
] or [ ] button to select "DRC", press the [ENTER] button to
] or [ ] to display the "Prune" submenu, then press the ENTER
or to show the "SYSTEM" submenu, then press the ENTER button
or to select "Preset Recall", then press [ENTER] to tune to the
- EN 8 -
. The display will return