Philips FastCare HI7700 Serie Mode D'emploi page 8

ENGLISH
8
6DIHW\ DXWRRII PRGH VSHFLÀF W\SHV RQO\
- To save energy, the steam generator switches off automatically when it has not been used for
 PLQXWHV 7KH ¶LURQ UHDG\· OLJKW ÁDVKHV
- To reactivate the steam generator, set the on/off switch to 'off ' position and then to 'on' position.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, visit www.philips.com/support
IRU D OLVW RI IUHTXHQWO\ DVNHG TXHVWLRQV RU FRQWDFW WKH &RQVXPHU &DUH &HQWUH LQ \RXU FRXQWU\
Problem
The iron does not
produce any
steam.
The Calc-Clean
OLJKW ÁDVKHV DQG
the appliance
beeps.
The Calc-Clean
OLJKW ÁDVKHV DQGRU
the appliance
beeps.
The Calc-Clean
OLJKW ÁDVKHV DQG
the appliance
beeps every time I
press the steam
trigger. No steam
comes out of the
soleplate.
4239_000_9925_1_DFU-Simple_A5_v3.indd 8
Possible cause
There is not enough water in
WKH ZDWHU WDQN
You have not pressed the steam
trigger.
You have set the temperature
dial to 1.
The steam function has been
disabled until you have
performed the Calc-Clean
process.
You have not placed the water
WDQN LQ WKH DSSOLDQFH SURSHUO\
This is the Calc-Clean reminder.
You have not done or have not
completed the Calc-Clean
process.
You have not done or have not
completed the Calc-Clean
process.
Solution
)LOO WKH ZDWHU WDQN EH\RQG WKH 0,1
indication. Press and hold the steam
WULJJHU XQWLO VWHDP FRPHV RXW ,W PD\ WDNH
up to 30 seconds until steam comes out.
Press and hold the steam trigger until
steam comes out.
Turn the temperature dial to 2 or
higher.
Perform the Calc-Clean process to
restore the steam function (see chapter
'IMPORTANT - Cleaning and
maintenance').
6OLGH WKH ZDWHU WDQN LQWR WKH DSSOLDQFH
XQWLO LW ORFNV LQWR SODFH ¶FOLFN· 
Perform the Calc-Clean process within
1 hour after the Calc-Clean reminder is
given.
Perform the Calc-Clean process to
enable the steam function again
(see chapter 'IMPORTANT - Cleaning
and maintenance').
Perform the Calc-Clean process to
enable the steam function again (see
chapter 'IMPORTANT - Cleaning and
maintenance').
17/08/15 13:38