Shutting Down; Maintenance And Care; Troubleshooting - Kärcher NT 35/1 Eco BS Mode D'emploi

Note
Automatic filter cleaning is switched on at
the factory.
Note
The automatic filter cleaning function can
be switched on/off only when the appliance
is switched on.
– To switch off automatic filter cleaning:
Activate the switch. Indicator lamp in
the switch goes off.
– To switch on automatic filter cleaning:
Press the switch again. Indicator lamp
in the switch glows green.

Shutting down

Turn off the appliance.
Pull out the mains plug.
Empty the container.
Vacuum and wipe the appliance inside
and outside.
Store the suction hose and the mains
cable as shown in the illustration.
Place the appliance in a dry room and
secure it from unauthorized use.
10
English

Maintenance and care

Warning
First remove the mains plug before doing
any job on the vacuum cleaner.
Exchanging the flat pleated filter
Open filter door.
Replace the flat pleated filter.
Close the filter door, it must lock into
place.
Cleaning the electrodes
Release and remove the suction head.
Clean the electrodes.
If necessary, clean the upgrade kit for
non-conducting media (optional).
Insert and lock the suction head.

Troubleshooting

Suction turbine does not run
Check cables, plugs, fuse, socket and
electrodes.
Turn on the appliance.