La-Z-Boy Luxury-Lift Instructions page 12

Luxury-Lift
Troubleshooting
ERROR
CAUSE
CODE
E39 The seat massage unit
is not connected under
the seat.
(Only applies to 1ML styles.)
E40 The back massage unit is
not connected inside the
lower back.
(Only applies to
1ML styles.)
22
® Power Recliner
SOLUTION
1. Unplug the transformer from the wall outlet, and
disconnect from the connector behind the chair.
2. Gently roll the chair forward to rest on the front
arms. The seat massage and heat connectors are
attached to the bottom of the seat springs, under
the chair.
3. The seat massage
connectors are brown.
Push the brown
connectors together
until they lock.
4. Gently roll the chair back
onto the base. Reconnect transformer into
the connector behind the chair, and plug
the transformer directly into a wall outlet.
1. Unplug the transformer from the wall outlet, and
disconnect from the connector behind the chair.
2. Gently roll the chair forward to rest on the front
arms. Push the outside back down, toward the
floor, to move the inner body from the outer
body. Lift the lower outside back cover to
separate the fastening tape, and access the
back springs. The back massage and heat
connectors are attached to the back springs.
3. The back massage
connectors are green.
Push the green connectors
together until they lock.
4. Press the fastening tape
together to attach the
lower outside back cover
to the inner body. Lift the back and push the
inner body into the outer body.
5. Gently roll the chair back onto the base.
Reconnect transformer into the connector
behind the chair, and plug the transformer
directly into a wall outlet.
ERROR
CODE
E41
step 3
E42
step 3
Luxury-Lift ® Power Recliner
Troubleshooting
CAUSE
The seat heating pad 1. Unplug the transformer from the wall outlet, and
is not connected under disconnect from the connector behind the chair.
the seat.
2. Gently roll the chair forward to rest on the front
(Only applies to 1ML arms. The seat massage and heat connectors are
and 1HL styles.) attached to the bottom of the seat springs,
under the chair.
3. The seat heating pad
connectors are black
and red. Push the black
and red connectors
together until they lock.
4. Gently roll the chair back
onto the base. Reconnect transformer behind the
chair, and plug the transformer directly into a
wall outlet.
The back heating pad 1. Unplug the transformer from the wall outlet, and
is not connected inside disconnect from the connector behind the chair.
the lower back.
2. Gently roll the chair forward to rest on the front
(Only applies to 1ML arms. Push the outside back down, toward the
and 1HL styles.) floor, to move the inner body from the outer body.
Lift the lower outside back cover to separate the
fastening tape, and access the back springs. The
back massage and heat connectors are attached
to the back springs.
3. The back heating pad
connectors are black
and red. Push the black
and red connectors
together until they lock.
4. Press the fastening tape
together to attach the lower outside back cover
to the inner body. Lift the back and push the
inner body into the outer body.
5. Gently roll the chair back onto the base.
Reconnect transformer into the connector
behind the chair, and plug the transformer
directly into a wall outlet.
(Troubleshooting Continued)
SOLUTION
step 3
step 3
23