Publicité
Les langues disponibles
Les langues disponibles
Overview
Note the vertical position
of the claw, and repeat the
process for the other tower.
Check both towers and
readjust as necessary.
Center round bar.
Center the bar so
that the ends of the
crossbar protruding
from the towers are set
to an equal distance.
Complete assembly of tower/bar system.
Check your work.
CHECK THE INSTALLATION!
Grip the crossbar inboard to towers;
push and pull using only arm strength.
The vehicle should rock back and forth,
but the RailGrabs should not budge.
1033604D-7/27
Claw Set Up
set of towers
Locate the silver
bar tightener.
Install first
Determine
crossbar spread
YOU
ARE
HERE
Be sure to tighten both towers!
Install second set
of towers
TIP: Look at the markings
on the claw base relative
to the markings on
the claw, and use this
measurement to help in
adjusting the other tower.
Assemble bar to tower by
tightening silver bar screw using
integrated assembly device.
Publicité
