Yakima RailGrab 2 Mode D'emploi page 6

Install first Determine Install second set
Overview Claw Set Up
set of towers crossbar spread of towers
YOU
ARE
HERE
The goal is to move the claw vertically and horizontally to
fit with your factory rail. These adjustments must be made in
tandem. You must establish three solid points of contact.
Adjust the claw vertically.
Adjust the claw horizontally.
With the RailGrab
covers open...
Locate the black
claw tightener.
Loosen knob.
NOTE: It may be
necessary to alternate
between step 3 and step
4 until a solid connection
Complete claw adjustment by
is achieved.
securing the black claw tightener
with the integrated assembly device.
Horizontal
Adjust claw
vertically.
Tighten
knob.
Check your work.
CONTACT POINT 1
Did you establish three
solid contact points?
Note: rounded factory racks may
CONTACT POINT 2
CONTACT POINT 3
only require two points of contact.
1033604D-6/27