Cleaning And Care - Klarstein EISZEIT CRUSH Mode D'emploi

EN
26 26

CLEANING AND CARE

• Clean the inside, ice collector, water container, ice shovel and evaporator of
the appliance regularly. To clean, first unplug the appliance from the wall
outlet and remove the ice cubes. Use a vinegar solution diluted with water
to clean the inside and outside of the appliance. Do not spray chemicals or
thinners, such as acids, gasoline, or oil, into the interior of the appliance. Rinse
the unit with water before using it again.
• Make sure that the ventilation openings of the unit are not blocked. Do
not use mechanical equipment or other means not recommended by the
manufacturer to speed up the defrosting process.
• If the unit is not used again for a long time, the water pump may not be able
to pump sufficient water due to air in the water supply line. If this is the case,
the symbol for insufficient water is also displayed. To correct this, press the
start button. The appliance will then function as usual.
• To ensure the purity of the ice cubes, the water should be changed every
24 hours.
• If the appliance does not work due to water shortage, too much ice, no
electricity, etc., Turn the appliance off, wait for three minutes and then restart
the appliance.
• Always use fresh water to make ice cubes. This applies to the initial installation
as well as if you use the appliance again after a long time.
• This appliance is designed for household use only. The appliance is not
designed for outdoor use. However, if it is to be used outdoors, make sure
that the viewing window is closed.