Sentiotec wave.com4 sound&light Instructions De Montage Et Mode D'emploi page 34

Instructions for use for the user
or in
● Slave operation
● Selection „SAU", with sauna base section as Master
● Setting for use with Wave.com4 Sauna control
1. Disconnect 4-pin bus/supply cable from the operating element
2. Simultaneous pressing of the keys
3. Plug in cable again when pressing the key.
4. The display flashes and the mode set for the operating element appears
(SIN or SAU)
5. Set the mode with the keys
6. Confirm input with the key
(siehe „REMOTE START ACTIVATE/ DEACTIVATE" auf Seite 14)
REMOTE START ACTIVATE/ DEACTIVATE
In the remote start mode, the coloured lamp switches after connection of the
mains voltage to the last den activated operating mode. (no standby operation)
The remote start function is activated as follows:
1. After setting and confirming the mode (SIN/SAU) by pressing the key
the remote start setting flashes.
(Po0 bzw. Po1)
2. Set the operating mode with the keys
Po0.......no remote start mode
Po1.......remote start mode active
3. Confirm inputs with
WORLD OF WELLNESS
5
and
5 6
and jump to the „Fernstart Aktivierung"
7
to save the changes
7
and .
6
.
and .
5 6
p. 14/20
,
7