VINCENT SA-32 Manuel D'utilisation page 26

S1 S2 S3 S4
9
9. INPUT: Terminal for stereo audio signals
of the source equipment
Here you find five stereo RCA input sockets for
source equipment with analogue stereo (line level)
audio output.
10. REC OUT: Output connectors assigned to
a recording device
If desired, you can connect a recording device
like a CD recorder or a tape recorder to this out-
put. The stereo signal of this output is identical to
the output signal of the selected audio source at
one of the preamplifier inputs.
11. XLR-IN
Here you find one stereo input sockets for source
equipment (1x XLR) with analogue stereo
(line level) audio output.
12. OUTPUT: preamplifier outputs
With these two pairs of connectors you can con-
nect the preamplified stereo audio signal of the
currently selected source to the power amplifier
channels.
Vincent
26
REAR VIEW
S5
XLR IN
10
XLR OUT
12
13
13. XLR-OUT
With these pair of connectors you can connect
the preamplified stereo audio signal of the cur-
rently selected source to the power amplifier
channels. The volume and mute settings have
effect on the signal at this output.
14. Voltage Selector:
The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V. Refer to
safety instructions for further information (p. 32).
15. POWER CONTROL: ON/OFF control
These jack connectors (3.5 mm) provide the
on/off signal for the standby control (12V
Trigger).
16. C 220-240V: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitable
wall outlet.
15
16
14