Publicité
Les langues disponibles
Les langues disponibles
6. If you insert the USB flash drive and the SD/MMC into the unit at the same time: press the
RECORD button (24) to start synchronised recording; "USB" will be displayed. Then press the
BACK/NEXT button to select recording to USB or card and press the RECORD button to confirm.
7. Press the STOP button (15) to stop recording.
COPYING FROM USB TO SD OR FROM SD TO USB
1. Insert the MP3 player or USB flash drive into the USB slot and the SD card into the SD card slot.
Set the FUNCTION button to USB and press the RECORD button. "CHE" will flash on the display
for around 3 seconds and then "ONE" will be displayed. Press the BACK/NEXT buttons (15, 17)
to record "ONE" track, or "FOL" or "ALL". Press the RECORD button to confirm.
2. Press the BACK/NEXT buttons (15, 17) to select the track and then press the RECORD button to
confirm. "COPY CARD←" will be displayed, indicating that it is being recorded to USB. The
display will indicate from 1 to 100% during copying.
3. Do not interrupt the copying process until completed or none of the files be copied.
After loading the USB / SD, the total number of tracks / files will be shown on the display and play
automatically. Press the STOP button to stop playing.
Remark: Please note that the unit can only read FAT32 format USB drives with less than 32GB.
1. Set the FUNCTION button to TAPE mode and then insert the tape into the compartment. The
cassette will play automatically.
2. Press and hold the FF button until you reach the desired position on the tape.
3. Release the FF button to the 'PLAY' position to start playback.
4. Eject the cassette tape after use.
1. Set the FUNCTION button (12) to PHONO mode and then use an audio cable (not included) with a 3.5
mm stereo plug on each end of the cable.
2. Plug one end of the cable into the AUX-IN jack (30) on the back of the unit ("Aux" will be displayed)
and the other end into the Line-out jack or Headphone jack of your external audio device to be able to
listen to the external source through that system's speakers.
3. The volume level can now be controlled through the main unit. Operate all other functions on the
auxiliary device as usual.
Note:
(1). If the Line-Out jack of your external device is connected, you only need to adjust the system's volume
control. If your external device's Headphone jack is connected, you may need to adjust the volume control
on both your external device and this system to achieve the desired volume.
(2). Press the POWER button (11) to turn off the system when you have finished listening. Don't forget to
switch off the power on your external device as well.
---
SPEAKER CONNECTION FOR EXTERNAL SPEAKERS - RCA JACK
You can connect the external speakers (4 ohm) via the "Speaker output" L, R sockets (cables and external
speakers are not included).
Note: Sound will still come from the original built-in speakers even after the external speakers are connected.
OPERATING THE USB / SD
OPERATING THE CASSETTE PLAYER
AUXILIARY INPUT
9
-
Publicité
