HeatStar MH9BX Guide D'utilisation Et Instructions De Fonctionnement page 5

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
LIGHTING / OPERATING
INSTRUCTIONS FOR USE WITH
DISPOSABLE 1 LB. PROPANE
CYLINDERS:
WARNING: Always inspect propane cylinder and heater
propane connections for damage, dirt, and debris before
attaching propane cylinder. Do not use if head of cylinder is
damaged, punctured or deteriorated.
ALWAYS ATTACH OR DETACH CYLINDER OUTDOORS AWAY
FROM FLAMES, OTHER IGNITION SOURCES, AND ONLY WHEN
HEATER IS COOL TO TOUCH. NEVER SMOKE WHEN ATTACHING
OR REMOVING PROPANE CYLINDER OR MAKING REMOTE
CONNECTIONS!
•
Use only 16.4 oz. (1 lb.) disposable cylinders that mate
with No. 600 valve connection.
•
Heater and attached cylinder must be in an upright posi-
tion during operation.
IMPORTANT: The heater
must not be exposed
to flammable vapors or
liquids during lighting.
1. Make sure four-position
Control Knob is in
"OFF" position; see
Figure 1.
2. Swivel regulator out-
ward for easy tank
installation. Screw 1 lb.
disposable LP-gas sup-
ply cylinder clockwise
(from bottom) into por-
table heater until hand-
tight; see Figure 2. DO
NOT use thread sealant
on this connection.
3. Check cylinder
connection for leaks
with soapy water at the
threaded connection
under the domed
plastic cover where the
cylinder screws into the
regulator. SEE
WARNING! ON
Figure 2: Attach fuel tank
DOMED PLASTIC COVER.
Figure 1: "Off" position.
HeatStar | Portable Propane Heater
4. Turn Control Knob coun-
terclockwise to "PILOT"
position and depress to
light. See Figure 3.
5. After pilot lights, hold
down for 30 -60
seconds and then
release knob. Knob
should return to fully
extended position. See
Figure 4.
6. To operate heater
slightly depress knob
and gently turn
to lock in the "HI"
position to light
burner tile. Leave on
"HI" position until
burner tile turns
bright orange.
7. After burner tile has
turned bright orange,
adjust heat output by
turning Control Knob
to desired position
("LO" or "HI" setting).
Warning:
DO NOT OPERATE HEATER UNLESS CONTROL KNOB
IS LOCKED IN A POSITION MARKED "HI", "LO" OR
"PILOT". NEVER SET CONTROL KNOB BETWEEN LOCKED
POSITIONS. POOR COMBUSTION AND HIGHER LEVELS
OF CARBON MONOXIDE MAY RESULT.
•
To shut off heater, slightly push down and turn Control
Knob clockwise to "OFF" position.
•
CAUTION: After turning heater off, wire guard will
remain hot. Allow to thoroughly cool before storing.
•
Do not operate, store or remove cylinder near
flammable items or ignition sources.
•
LP-GAS CYLINDERS MUST BE DISCONNECTED FROM
HEATER WHEN NOT IN USE!
5
Operating Instructions and Owner's Manual
Figure 3: Ignition
Figure 4: Release knob.