weinor Terrazza Pure Instructions De Montage page 58

Terrazza Pure | 123313-0000 w | v8.3 | 2020-03-18 | Montageanleitung | Montagehandleiding | Instructions for assembly | Instructions de montage
Fault
Creaking noises in the guttering or
roof support
Condensation on glass panes
Pimples on powder-coated parts
Minor deviations in the colour of
powder-coated parts
Minor scratches on powder-
coated parts
Flash rust, pollutants
Decor strips have marks on the
surface after removing the pro-
tective film
58
Technische Änderungen vorbehalten | Technische wijzigingen voorbehouden | We reserve the right to make technical changes | Sous réserve de modifications techniques
Cause
– Different materials expand differently
when warm. This may result in an audi-
ble creaking sound.
– Condensation forms as a result of water
vapour in the air dripping onto cold sur-
faces when the air is below its so-called
dew point temperature.
– Minor accumulations have arisen while
powder coating the parts.
– Despite using the same RAL colours,
there is always a possibility of two parts
being slightly different in colour. This
especially occurs when using metal or
iron effect paint.
– Possible transport damages
(Check packaging)
– Production tolerances
– Particles in the air settle on the unit's
components, resulting in minor traces
of corrosion.
– The usual adhesive residue can be seen on
the surface after removing the protective
film
Remedy
None, as the expansion is unavoidable.
Cannot be remedied. The possibility of condensation occur-
ring cannot be excluded.
The amount of condensation can be reduced by: airing,
heating, change of use.
Cannot be remedied.
A visual assessment is generally made in accordance with
the guidelines of the respective national
associations and/or the manufacturers.
Cannot be remedied.
A visual assessment is generally made in accordance with
the guidelines of the respective national
associations and/or the manufacturers.
Touch-up pen
A visual assessment is generally made in accordance with
the guidelines of the respective national
associations and/or the manufacturers.
Treat with water and/or standard household stainless steel
cleaners.
Carefully remove the adhesive residue using a suitable soft
cloth or cleaning eraser without leaving any scratches.