Constitutes And Names Of Every Part Of Indoor Unit - Gree GMV-ND22C/A-T Manuel D'utilisateur

 Install the connection pipes
Connect the connect pipe with the two relative leading pipe, tie the nut on tie in of the connect
pipe tightly.
Notes:
①. Be careful in bending the connection pipes, or you will damage the pipes.
②. If the tightening torque is too great in tightening the flare nut, leakage will happen.

3 Constitutes and Names of Every Part of Indoor Unit

Cautions
①. Before opening the front panel, be sure to stop the operation and turn the breaker OFF.
②. Do not touch the metal parts on the inside of the indoor unit, as it may result in injury.
（1）Titanium Apatite Photocatalytic
Air-Purifying Filter:
These filters are attached to the inside of the air filters.
（2）Air outlet
（3）Display
（4）Front panel
（5）Louvers (vertical blades)
The louvers are inside of the air outlet.
（6）Air inlet
（7）Air filter
（8）Flap (horizontal blade)
（9）Cool mode lamp
（10）Heat mode lamp
（11） Dry mode lamp
（12）Run lamp
（13）LED display
（14）Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
• Push once again to stop it.
• The operation mode refers to the following table.
Model
HEAT PUMP
• This switch is useful when the remote controller is missing.
（15）Signal receiver:
• It receives signals from the remote controller.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Multi Variable Air Conditioners Floor and Wall Mounted Type Indoor Unit
Mode
AUTO
Temperature seting
26℃
13
Air flow rate
AUTO