Husqvarna Weed Eater B230i Manuel D'instructions page 9

Store the battery pack fully charged.
STORING THE POWER TOOL
1. Remove the battery pack.
2. Remove debris with a soft brush or dry cloth. Never
clean with water, cleaning fl uids, or solvents.
3. Use a soft brush to remove debris from the air vents.
4. Inspect the tool carefully. If the tool is damaged in any
way, contact an authorized service center. Never use a
a WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
Trouble
The motor fails to start when the
trigger is squeezed.
The power tool will not start.
Rated voltage
Airfl ow
Air velocity
Weight without battery
Weight with battery
Charge time
Environmental protection
• Waste electrical products should not be disposed of with household waste.
• Please recycle where facilities exist.
• Check with your local authority or retailer for recycling advice.
The following toxic and corrosive materials are in the battery pack: Lithium-Ion
a WARNING: All toxic materials must be disposed of in a specifi ed manner to prevent
contamination of the environment. Before disposing of damaged or worn out lithium-ion
battery packs, contact your local waste disposal agency, environmental authority, or retailer
for information and specifi c instructions. Take the batteries to a local recycling and/or
disposal center, certifi ed for lithium-ion disposal.
TROUBLESHOOTING
Cause
1. Battery pack is not secure.
2. Battery pack is not charged.
1. Attachment not correctly
assembled in the powerhead.
2. Battery pack is not secure.
3. Battery pack is not charged.
4. Defective power switch.
TECHNICAL DATA
PARTS & ACCESSORIES
Description
Powerhead
Blower attachment
Hedge trimmer attachment
Grass trimmer attachment
Battery pack only
Charger only
damaged tool.
5. Store in a cool, dry place and out of reach of children.
STORING THE CHARGER
• Remove debris with a soft brush or dry cloth. Never
clean with water, cleaning fl uids, or solvents.
• Unplug the charger when there is no battery pack in it.
• Store the charger at normal room temperature. Do not
store it in excessive heat.
Remedy
1. Make sure the battery pack is fully
secured in the power tool.
2. Charge the battery pack.
1. Assemble the attachment correctly in
the powerhead.
2. Make sure the battery pack is fully
secured in the power tool.
3. Charge the battery pack.
4. Call an authorized service center
20V
3
7.1 m /min (250 cfm)
35.7 m/s (80 mph)
1.8 kg (3.96 lb)
2.2 kg (4.85 lb)
3 hours
Part number
592643801
593106401
593106501
593106601
591088401
591088501
9