Timer; The Device Shows Lo; Cleaning And Maintenance; Safety Information - CASO DESIGN Perfect Cup Mode D'emploi Original

4.7.5

Timer

Finish the preparations and set the strength of the flavor of the brewed coffee. For making
coffee from coffee beans set the desired grinding degree. For making coffee from ground
coffee select the function for this with
The clock has to be set already. Then hold
desired start time for the brewing or brewing and grinding process. Set the hour with
and confirm with
Then lights up in red and the timer is activated.
If you have previously set the timer, then press
displayed. Confirm it with
If you want to deactivate the timer, then press
4.7.6

The device shows Lo

There is not enough water in the watertank for the desired quantity of cups. The device
switches to keep warm mode after 5 beeps and will not automatically go on with brewing
even if you refill the watertank. Therefore, the coffee could be too strong for your taste.
In this case: Fill water to maximum mark in the water tank. Chose function for making
coffee from ground coffee for the not brewed quantity of cups and start the process.
5

Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

5.1 Safety information

ATTENTION
Please observe the following safety notices, before you start cleaning the device:
► The device (especially the grinder) must be cleaned at regular intervals and limescale
should be removed.
► Always descale the device regularly to ensure optimum performance and prevent
malfunction.
► Switch the device off prior to cleaning it and unplug the plug.
, so that the button lights up in red.
until the time flashes. Then set the
. Then set the minute with
. Then lights up in red and the timer is activated.
and confirm with
only briefly, then the set timer is
, so that the button lights up in white.
..
18