Weller WX 1011 Mode D'emploi page 21

Error messages and error clearance
Message/symptom
Display: „- - -
No display function display OFF
OFF
Channel cannot be switched on
WXD 2:
No vacuum at desoldering tool
WXD 2:
Insufficient vacuum at desolde-
ring tool
WXA 2:
Hot air tool has no air
rear port
Does not function with Zero
Smog/ WHP/PC/ WFV 60A
front port
Does not function with Zero
Smog/ WHP/PC/ WFV 60A
Possible cause
Tool has not been detected
„
Tool defective
„
No mains supply voltage
„
Overload cut-out
„
Channel switched off
„
Vacuum not connected
„
Desoldering nozzle clogged
„
Compressed air not or
„
incorrectly connected
Filter cartridge on desoldering
„
tool full
Main filter on soldering station
„
full
Air hose not connected
„
Compressed air not or
„
incorrectly connected
Robot output set to Stop/Go
„
Footswitch is on
„
Remedial measures
Check connection of tool to
„
device
Check connected tool
„
Turn on mains power switch
„
Check mains supply voltage
„
Check device fuse
„
Only one soldering iron can be
„
operated.
Connect vacuum hose to
„
vacuum connection
Service desoldering nozzle
„
using cleaning tool
Connect compressed air to
„
compressed air connection or
check
Change filter cartridge on
„
desoldering tool full
Change the main filter element
„
on the soldering station
Connect compressed air to
„
compressed air hose or check
Connect air hose of tool to
„
WXA 2 or check
Deactivate Stop & Go function;
„
Or use front RS 232 port
Deactivate Footswitch; Or use
„
rear RS 232 port
39