Grandhall Xenon 3 X3S-VF1 Instructions D'assemblage page 6

MAINTENANCE
CLEANING THE BURNER TUBES AND
BURNER PORTS
To reduce the chance of FLASHBACK FIRE you must
clean the burner tubes as follows at least once a month
in summer and fall or whenever spiders are active in
your area, and if your barbecue has not been used for
an extended period of time.
Turn all burner valves to the full "OFF" position.
2 Turn the LP gas cylinder valve to the full
"OFF" position.
3. Detach the LP gas regulator assembly from your
gas barbecue.
4. Remove the cooking plates from your barbecue.
5. Remove the cotter pin from the rear of each burner
using a nose plier.
6. Carefully lift each burner up and away from the
gas valve orifice.
7. Check and clean burner / venturi tubes for insects
and insect nests. A clogged tube can lead to a
fire beneath the barbecue.
8. Refer to diagram 1 and perform one of these three
cleaning methods:
METHOD 1: Bend a stiff wire or wire coat hanger into a
small hook as shown and run the hook through the
burner tube and inside the burner several times to
remove debris.
Diagram 1
To clean burner tube, insert hook as indicated by the
arrow.
9
Burner Tube
METHOD 2: Use a bottle brush with a flexible handle
and run the brush through the burner tube and inside
the burner several times to remove any debris.
METHOD 3: Use an air hose to force air through each
burner tube. The forced air should pass debris or
obstructions through the burner and out the ports.
Regardless of which burner cleaning procedure you
use, we recommend you also complete the following
steps to help prolong burner life.
1. Use a fibre pad or nylon brush to clean the entire
outer surface of each burner until free of food
residue and dirt.
2. Clean any clogged ports with a stiff wire, such as
an open paper clip.
3. Inspect each burner for damage (cracks or holes)
and if such damage is found, order and install a
new burner. After installation, check to ensure
that the gas valve orifices are correctly placed
inside the ends of the burner tubes. Also check the
position of your spark electrode.
FOR SAFE OPERATION ENSURE THE GAS
VALVE ASSEMBLY ORIFICE IS INSIDE THE
BURNER TUBE BEFORE USING YOUR
BARBECUE.
IF THE ORIFICE IS NOT INSIDE THE
BURNER TUBE, LIGHTING THE BURNER
MAY CAUSE EXPLOSION
AND / OR FIRE RESULTING IN SERIOUS
BODILY INJURY AND / OR PROPERTY
DAMAGE.
Burner Port
6