Grandhall Xenon 3 X3S-VF1 Instructions D'assemblage page 3

ENSURING BURNER CONTROLS ARE OFF
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are
in 'OFF' position.
NOTE: The 'OFF' position on the control panel is
identified by either a small black dot / a short vertical
black line / or the word 'OFF'.
CAUTION: When the appliance is not in use, the
gas must be turned off at the gas cylinder.
Familiarise yourself with the general information
and safety guidelines located at the front of this
booklet. Check to see that gas cylinder is filled and
that end of each burner tube is properly located
over each valve orifice.
'OFF' position.
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE CONNECTING TO GAS
SOURCE
1. Locate the gas cylinder in the cabinet and secure.
2. Attach the regulator and
hose assembly to cylinder
valve outlet.
Tighten firmly.
3. Open the gas
cylinder valve
fully to allow gas
to flow.
4. Leak test all accessible
connections thoroughly
using a soapy water
solution prior to lighting the
barbecue.
If a leak is found, turn gas cylinder valve off and
5.
re-check all connections have been tightened.
If there is still a leak do not use barbecue
until repairs or replacement can be made.
Set burner controls to
DISCONNECTING FROM GAS SOURCE
Turn the burner controls 'OFF'.
1.
Turn the gas cylinder valve off fully.
2.
Detach the regulator assembly from gas
3.
cylinder valve.
NOW YOUR BARBECUE IS READY TO USE
Before first use and at the beginning of each barbecue
season:
1 Please read Safety, Lighting and Operating
instructions carefully.
2 Check gas valve orifices, burner tubes and burner
ports for any obstructions. eg. spiders, webs, insects.
3 Check and ensure the gas cylinder is full
4 Ensure all connections are securely tightened.
Check for gas leaks.
INSTALLER FINALCHECK LIST
1 At least 1m clearance maintained from combustible
constructions to the sides and back of this grill.
There is no unprotected combustible construction
2
over the grill.
All internal packaging removed.
3
Burners are sitting properly on orifices.
4
Knobs turn freely.
5
Unit tested and free of leaks.
6
User informed of gas supply shut off valve location.
7
3