Velleman CAMZWEXT2N Mode D'emploi

1. Installation
This camera plugs into the SCART socket of a standard TV or VCR. Consult the manual for your TV or VCR when
you want to tune into the A/V channel. Connection to your VCR allows you to make tape recordings. The camera is
equipped with a built-in microphone and can be mounted either indoors or outdoors in a sheltered position. This
device is ideal as a baby monitor and as a safety device for your car, your home, etc.
Contents :
Contents
1. camera and bracket with cable
2. SCART cable, length 17m
3. mains adapter (12Vdc/300mA)
4. 6-pin mini-DIN plug (male)
5. 6-pin mini-DIN plug (female)
2. Installation (see figures at the back of the manual)
- Fix the camera on the ball joint by carefully tightening the small silver screw on the base of the camera arm. DO
NOT OVERTIGHTEN.
- Connect the male mini-DIN plug (4) on the camera lead into the female mini-DIN plug (5) of the SCART cable.
- Connect the SCART plug (6) with the SCART socket on your TV or VCR.
- Plug the mains adapter (3) into a wall socket, connect mini jacks (7) & (8) and switch the device on.
- Switch on your TV and tune into the A/V channel.
The A/V channel can only be selected by pressing the correct button on the TV or its remote control. This button is
marked 'A/V' or 'AU' or it can even bear an arrow. Please refer to the manual of your TV if you cannot access your
A/V channel. The picture and audio signal from the camera are available on the A/V channel. The device will produce
a whistling sound if the camera is too close to the TV. Test the camera's performance at the desired location prior to
permanent mounting. Make the necessary adjustments until optimum performance is reached.
CAMZWEXT2N
CAMZWEXT2N : CCTV CAMERA SYSTEM
6. SCART plug
7. mini jack (female)
8. mini jack (male)
9. two fixing screws and masonry plugs
1 VELLEMAN