Installation Instructions - Inventum IWL6014GT Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
The crockery is not warm
enough.
The crockery is too hot.
A noise can be heard when the
warming drawer is being used.
9

installation instructions

• The safety during use can only be guaranteed when the oven is installed correctly and according to the regulations. The installer is
responsible for any damage caused by a faulty installation.
• The electrical connection must be made by a qualified electricien. This person is aware of the national and local regulations the
installation must comply with.
• The manufacturer accepts no responsibility for any malfunction or damage caused by incorrect electrical installations.
The appliance must be connected to a fixed installation and the means of disconnecting it from the fixed installation must be
installed according to the installation instructions.
• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. It must be positioned so that it
does not touch any of the hot parts of the appliance.
• The connection point, the wall socket and/or plug must always be accessible.
• The warming drawer may only be built in combination with those appliances quoted by Inventum as being suitable. Inventum
cannot guarantee trouble-free operation if the appliance is operated in combination with appliances other than those quoted as
being suitable.
• When building in the warming drawer in combination with another suitable aplliance, the food warming drawer must be fitted above
a fixed interim shelf in the cabinet. Please ensure that the housing unit can support both its weight and that of the other appliance.
• As the combination appliance is placed directly on top of the warming drawer once it is built in, an interim shelf is not necessary
between the two appliances. The combination appliance may weigh a maximum of 50 kg.
• The appliance must be built in so that the contents of the drawer can be seen. This is to avoid scalding from hot food spilling over.
There must be enough space for the drawer to be pulled out fully.
• The cabinet into which the oven is fitted, must be heat resistant (> 60°C). This also applies to the doors and the fronts of the
cabinets.
• Ensure that the cabinet into which the appliance is installed is secure. For example, by mounting it to the adjoining elements.
• Damage caused by incorrect connection, incorrect use or incorrect fitting is not covered by the guarantee.
• Attention: any change to the appliance's interior, including fitting and changing the power cable, must only be performed by a
qualified electricien.
Possible cause
The function for warming plates and
dishes
is not selected.
The temperature setting is too low.
The vents are covered.
The crockery has not been allowed to
heat up for a sufficiently long time.
The function for warming plates and
dishes
or cups and glasses
not selected.
The temperature setting is too high.
The noise is caused by the fan which
distributes the heat evenly through the
drawer. The fan operates at intervals
when the functions for keeping food
warm and low temperature cooking are
being used.
Remedy
Select the correct function.
Select a higher temperature.
Ensure that the air can circulate freely.
Various factors will affect how long the crockery will
take to heat up.
Select the correct function.
is
Select a lower temperature.
This is not a fault.
29
English

Publicité

Table des Matières
loading

Table des Matières