Cleaning & Maintenance; Problems & Solutions - Inventum IWL6014GT Mode D'emploi

7
cleaining & maintenance
Switch the appliance off before cleaning and let it cool down. Do not clean the appliance with a pressure cleaner or steam cleaner.
Interior and the front
Clean the inside of the appliance and the front after every use. If this is not done, it might become impossible to remove and could
cause the surfaces to alter or discolour.
Use a damp cloth. If needed, use some washing-up liquid. Rinse well. Dry the inside with a dry cloth.
Warning! All surfaces are susceptible to scratching. Scratches on glass surfaces could even cause a breakage.
Contact with unsuitable cleaning agents can alter or discolour the surfaces.
To avoid damaging the surfaces of your appliance, do not use:
• cleaning agents containing soda, ammonia, acids or chlorides;
• cleaning agents containing descaling agents;
• abrasive cleaning agents, e.g. powder cleaners and cream cleaners;
• solvent-based cleaning agents;
• stainless steel cleaning agents;
• dishwasher cleaner;
• oven sprays;
• glass cleaning agents;
• hard, abrasive sponges and brushes, e.g. pot scourers;
• sharp metal scrapers.
Anti-slip mat
Remove the anti-slip mat from the drawer before cleaning it.
• Clean the anti-slip mat by hand only, using a solution of hot water and a little washing-up liquid, and then dry with a cloth.
Do not put the anti-slip mat back into the drawer until it is completely dry.
Do not wash the anti-slip mat in a dishwasher or washing machine.
Never place the anti-slip mat in the warming drawer to dry.
8
problems & solutions
With the help of the following guides, minor faults in the perfomance of the appliance, some of which may result from incorrect
operation, can be put right without contacting the customer service department.
Problem
The appliance does not heat up.
The food is not hot enough.
The food is too hot.
28
• English
Possible cause
The appliance is not correctly plugged
in.
The mains fuse has tripped.
The function for keeping food warm
is not selected.
The temperature setting is too low.
The vents are covered.
The function for keeping food warm
is not selected.
The temperature is set too high.
Remedy
Remove the plug and properly plug it in again.
Reset the trip switch in the mains fuse box. If, after
resetting the trip switch, the appliance will still not
heat up, contact the Inventum customer service.
Select the correct function.
Select a higher temperature.
Ensure that the air can circulate freely.
Select the correct function.
Select a lower temperature.