Nikon WT-1 Mode D'emploi page 23

SSID
A BSS- or ESS-ID is required for connection to a wire-
less LAN adapter or access point. Leave this fi eld
blank to allow network to set SS-ID automatically
("any" connection). To change the current BSS- or
ESS-ID, press the multi selector to the right and enter
an ID as described on page 14. Press the
return to the SS-ID display.
Encryption
Enter encryption settings according to how the net-
work is set up. Press the multi selector up or down
to highlight an option and press the multi selector to
the right to select.
• Done: Save changes and exit to wireless menu.
• On: Enable or disable encryption. ✔ appears when
encryption is enabled.
• Base 16: Enable or disable base-16 encryption. ✔ appears when base-16
encryption is enabled. Enable base-16 encryption to enter encryption key
in hexadecimal notation using only numbers 0–9 and letters A–F. Disable
base-16 encryption to enter encryption key in ASCII notation using standard
alphanumeric characters.
• 128 bit: Enable or disable 128-bit encryption. ✔ appears when 128-bit en-
cryption is enabled. If 128-bit encryption is disabled, 40-bit encryption will
be used.
• Encryption key: Highlight current key and press
multi selector to right to display edit dialog shown
at right. Press multi selector left or right to select
character, up or down to change. Press
to encryption menu. Length of key depends on
options selected for Base 16 and 128 bit:
Base 16 128 bit
— —
✔
—
✔
—
✔ ✔
16
button to
to return
Encryption key
Five characters (ASCII)
Ten characters (hexadecimal)
Thirteen characters (ASCII)
Twenty-six characters (hexadecimal)
SET UP
Wireless LAN
SSID
SET UP
Wireless LAN
Encryption
OK
Done
□ On
□ Base 16
□ 128 bit
SET UP
Wireless LAN
Encryption
Set OK
0000000000