Axis P13 Serie Guide D'installation page 12

AXIS P13 Series
Power LED
Green
Amber
Status LED Behavior for Focus Assistant
The status LED flashes when the Focus Assistant is active.
Indication
Color
Red The image is out of focus.
Adjust the lens.
Amber The image is close to focus.
The lens needs fine tuning.
Green The image is in focus.
Connectors and Buttons
For specifications and operating conditions, see page 14.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility (EMC) 2.
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection,
event triggering, time lapse recording and alarm notifications. In addition to the 0 V DC reference
point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected
devices can be activated by the VAPIX® Application Programming Interface, output
buttons on the Live View page or by an Action Rule. The output will show as active
(shown under System Options > Ports & Devices) if the alarm device is activated.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
12