Safety Notes; Important Notes; Functions; Spare Parts - LGB HGe 2/2 Serie Mode D'emploi

Safety Notes

• This locomotive is to be used with the operating system
designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or

spare parts.

• Disposing: www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC
systems with conventional LGB DC train controllers or
power packs (DC, 0 - 24 volts).
• Use a locomotive controller with more than 1 amp of train
current for this model.
8
Mode of Operation Switch
There is a power control switch located in the cab with the
engineer figure.
Pos. 0 All power off
Pos. 1 Track power to motor and lights
Pos. 2 same as Position 1
Pos. 3 Catenary power to motor and lights
CAUTION! This model may be powered with a catenary on
analog layouts only. For operation with the digital Multi-
Train System, the model must use track power. Otherwise,
dangerously high voltages may result.
Multi-Purpose Socket
The model has two "flat" multipurpose sockets, with remo-
vable covers, one on each end wall (Fig. 2). These sockets
can be used to provide track power to cars with lighting or
sound electronics.
Multi-Train System
The model is equipped with a factory-installed onboard de-
coder for the LGB Multi-Train System. It can be used without
modifications on analog or digital layouts. For operation
with the Multi-Train System, the model is programmed to
loco address 03. For information on programming the loco
address, see the instructions for various MTS components.
When operating with the Multi-Train System, you can remo-
tely control the loco's functions. Press the lighting button
("9" with remotes) to turn the loco lights on or off.
When operating with the Multi-Train System, the loco fea-
tures a "Back-EMF" function. This keeps the motor speed
constant (and under normal conditions the loco speed),