Safety - CLAS PE 6004 Mode D'emploi

PE 6004 PE 6001
DOUBLE SCISSOR LIFT 3T DOUBLE SCISSOR LIFT DUAL CYLINDER 3.5T
It is recommended that you read this chapter carefully and thoroughly as important notions
of the safety rules to be adopted by the operator and other users are provided, also in case
of improper use of the lift bridge. The following text provides clear explanations of certain
risk or danger situations that may arise during the use or the maintenance on the deck. It
is also illustrated the installed security device indicating the correct use of this system, the
residual risks and the operating procedures to be used (general precautions to eliminate
potential dangers).
The lift is designed and built for lifting vehicles and to keep them lifted to the desired
position in a circumscribed environment.
Any other use of the lift bridge is forbidden.
Especially, lifts are not suitable for:
- spray washing vehicles;
- persons lifting;
- crushing purpose through pressure system;
- used as elevator;
- used ad single vehicle parts elevator.
The manufacturer is not liable for any injury to persons or damage to vehicles and other
property caused by the incorrect and unauthorized use of the lifts.
During the lifting or lowering phase, the operator must remain in the station control zone
as shown in the diagrams.
As shown in the diagrams (Figure 5), the presence of personnel within the specifi ed danger
zone is strictly forbidden. During the up and down operations of the deck, personnel are
allowed in the area of interest only when the vehicle is already in a high position, when the
platforms are in a stationary position and when the mechanical safety devices are fi rmly
engaged.
Do not use the lift without protective devices or with the protective devices inhibited.
Failure to comply with these regulations may cause serious injury to persons, and irreparable
damage to the lift and the vehicle begin lifted.
34

SAFETY

Picture 5