Precautions - Kenwood NX-3000 Série Guide De L'utilisateur

Do not charge the transceiver and battery pack when they are wet.
●
Ensure that there are no metallic items located between the transceiver
●
and the battery pack.
Do not use options not specified by KENWOOD.
●
If the die-cast chassis or other transceiver part is damaged, do not
●
touch the damaged parts.
If a headset or headphone is connected to the transceiver, reduce the
●
transceiver volume. Pay attention to the volume level when turning the
squelch off.
Do not place the microphone cable around your neck while near
●
machinery that may catch the cable.
Do not place the transceiver on unstable surfaces.
●
Ensure that the end of the antenna does not touch your eyes.
●
When the transceiver is used for transmission for many hours, the
●
radiator and chassis will become hot. Do not touch these locations
when replacing the battery pack.
Always switch the transceiver power off before installing optional
●
accessories.
When water gets into the microphone opening or the speaker grill, the
●
voice level may become incoherent or distorted. Lightly shake the
transceiver to remove the water from the speaker and/or microphone
before operating the transceiver.
The charger is the device that disconnects the unit from the AC mains
●
line. The AC plug should be readily accessible.
To dispose of batteries, be sure to comply with the laws and regulations
●
in your country or region.

PRECAUTIONS

5