Kamikaze KV 4 Manuel D'utilisateur page 92

ELECTRONIC CORDLESS TYING MACHINE
• Do not try to remove the stuck feeding hook or tying wire before turning
off the machine.
• Tying work must be finished when feeding hook and wire-outgoing track
can stretch out and retract smoothly and there is no interference of other
foreign matters. Before staring the work of tying, please check objects
hidden in grave vines or branches, for example, electric wire, iron wire,
surplus branches and leaves, these things may affect the stretching out
and retracting of the feeding hook.
• When operating the tool, always hold it with one hand, and keep a
distance of at least 5cm away from the other hand and your whole body.
• Feeding system must be checked and cleaned frequently. If foreign
matters are accumulated in the feeding track, it will affect tying effect
and increase load to the equipment. Quality assurance does not include
the damage caused by the wrong maintenance mentioned above.
• Do not attempt to repair the tool yourself. Repair operations not
mentioned in this manual can only be performed by the personnel of our
service center.
• Use only the wire suggested by the producers. The usage of other wire
will invalid the warranty of the tool.
4.3. SPECIAL SAFETY INSTRUCTION FOR BATTERY TOOL
• Charger design for use only indoor. Charging operations have to be
performed indoor.
• Disconnect power before to clean the charger to avoid damage and risk
of electrical shock.
• Don't expose battery in strong light. Don't put battery on hot surface. It
can cause battery explosion.
• Fully cold battery before charging.
• Don't disassemble the battery, don't damage battery, in order to avoid injury.
• When not used the battery have to be recharged at least every 3 months,
otherwise it will be damaged. The warranty will not cover damages
caused by the missed respect of charging frequency.
92
www.kamikazevolpi.com