Kamikaze KV 4 Manuel D'utilisateur page 103

ELECTRONIC CORDLESS TYING MACHINE
If front end tying mouth is blocked by a foreign matter when tying
branches, please switch off the machine before removing the foreign
matter.
• Switch on the machine, the tying machine is in working state, start
working after pulling trigger.
• To save electric quantity and ensure that the tying machine has the
longest service life, don't overload the machine; don't use it to tie
branches exceeding 25mm.
• In the process of tying, if the tying is not successful, please switch off the
machine. Remove the tying wire failing to tie successfully from front end
tying mouth with hand, then switch on power.
• Conduct idle running once to see if it can tie successfully. If the tying
becomes normal, continue working.
• If the tying fails to be successful for several times, please switch off the
machine for inspection. Open front cover and pressing plate, check wire
at inlet and in the whole feeding track to see if there is any knotted,
accumulated, and jamming phenomenon, and clear up timely in case of
any abnormality.
• f tying machine stops half a way during tying, the feeding hook cannot
retract, and the tying machine is stuck on branches and cannot be lifted
up, please switch off the machine at first, then lift up feeding hook with
hand, and take off the tying machine.
• Check if the diameter of the branches exceeds 25mm.
• Check if it is stuck by any foreign matters.
13.1 TYING PROCEDURE
• When the equipment is operating, keep your other hand at least 5cm
away from the area of tying mouth; don't place your hand in the tying
mouth.
• Don't use the equipment to tie the branches with a diameter more than
25mm, otherwise the machine may get stuck. During tying operation, the
tying machine has to be be vertical to branches, and don't tilt or move
during tying process. The damage of the equipment caused by incorrect
operations is not covered by quality warranty.
103
www.kamikazevolpi.com