Kamikaze KV 4 Manuel D'utilisateur page 89

ELECTRONIC CORDLESS TYING MACHINE
3.2. ELECTRICAL SAFETY FOR BATTERY CHARGER
• Power tool plug must match the outlet. Never modify the plug in anyway.
Do not use any adapter plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce risk of electrical shock.
• Avoid body contact with earthed or grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
• Do not expose power tools to rain or wet conditions. Water entering a
power tool will increase the risk of electric shock.
• Do not abuse the cord. Never use the cord for carrying, pulling or unplugging
the power tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
• When operating a power tool out-doors, use an extension cord suitable
for outdoor use. Use of a cord suitable for outdoor use reduces the risk of
electric shock.
• If operating a power tool in a damp location is unavoidable, use a residual
current device (RCD) protected supply. Use of an RCD reduces the risk of
electric shock.
3.3. NOTICE OF USING THE TOOLS
• Don't over load the tool, select suitable tool to work make you safe and
high efficiency.
• Don't use the tool if the switch doesn't work properly. Tool should be
repaired if the switch doesn't work.
• Disconnect the battery from tool or power source before adjusting, repair,
replace or storage the tool. This will avoid injuries due to unexpected start
of the tool.
• Store the tool away from the children, don't put tool to non-training
person operate.
• Maintain tools. Always check tool, moving parts, any damage parts are
all can cause injury, the correct maintenance of the tool can avoid injury.
• Read manual before using the tool, select suitable tools and right
accessories to avoid injury.
89
www.kamikazevolpi.com