Operating Procedure - Kamikaze KV 4 Manuel D'utilisateur

ELECTRONIC CORDLESS TYING MACHINE
I. Pay attention to the direction
of the thread which must NOT
have knots, distortions or wrap-
around of any kind.
• After using up each roll of wire, timely clear up residual wire head. In the
process of tying, if tying is not successful, please use tweezers to clear
up residual wire timely, then continue working.

13. OPERATING PROCEDURE

Wear suitable cloth and glove when operate this tool. The power
should be put off when you loosen the trigger. Stop using the tool
in case of switch failure. Always check rated voltage of battery
match the tying machine
Confirm the work frequency of the tying machine and select
a suitable gear according to the conditions of usage, so as to
ensure that the tying machine is in the best state.
I
J. After positioning the thread, turn
on the power switch and pull the
trigger. Make sure that the thread
is correctly positioned into the
machine.
102
www.kamikazevolpi.com
J