Abus Terxon SX Mode D'emploi page 36

The control unit shows:
Walk through your alarm system and trigger the sensors.
If a sensor is triggered, this is reported acoustically by the
control units and the internal alarms. Simultaneously, the
control unit shows the zone that was triggered.
The control unit shows:
If more than one sensor is triggered, the zones are
alternately displayed one after the other.
After triggering all sensors, end the test by pressing
IMPORTANT: You can end the test at any time by
pressing
You cannot test fire, panic or 24 hour
zones.
You cannot test tamper contacts.
.
.
17
UK