Worx WX655 Notice Originale page 9

VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 60745:
Vibration emission value
Typical weighted
a
vibration
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10°C or less
Plan your work schedule to spread any high vibration
tool use across a number of days.
Random orbit sander
= 3.925m/s
2
h
ACCESSORIES
Cyclone dust box
60 grit velcro sanding paper
120 grit velcro sanding paper
180 grit velcro sanding paper
Dust extraction adapter
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for dry sanding of wood,
plastic, metal and filler material as well as painted
surfaces.
Machines with electronic control are also suitable for
polishing.
ASSEMBLY AND OPERATION
Action
ASSEMBLY
Fitting the Sanding Paper
Attaching the Cyclone Dust Box
CAUTION: To prevent the
possibility of sanding dust or
foreign body being thrown into your
face or eyes, never attempt to use
your sander without the dust box
properly installed.
Emptying the Cyclone Dust Box
For more efficient operation, empty
dusts box every 5-10mins.
Using the dust extraction adapter
OPERATION
On/Off Switch
1
10
10
10
1
9
Figure
See Fig.
A1, A2
See Fig. B
See Fig.
C1, C2
See Fig. D
See Fig. E
EN