Dolmar MS-20U Manuel D'instructions Original page 6

Never straighten or weld damaged cutting tools.
– Operate the Brush cutter or Grass trimmer with as little noise and
contamination as possible. In particular check the correct setting of the
carburetor.
– Clean the Brush cutter or Grass trimmer at regular intervals and check that all
screws and nuts are well tightened.
– Never service or store the Brush cutter or Grass trimmer in the vicinity of
naked flames.
– Always store the Brush cutter or Grass trimmer in locked rooms and with an
emptied fuel tank.
Observe the relevant accident prevention instructions issued by the relevant trade associations and by the insurance companies.
Do not perform any modifications on the Brush cutter or Grass trimmer as this will endanger your safety.
The performance of maintenance or repair work by the user is limited to those activities as described in the instruction manual. All other work
is to be done by an Authorized Service Agent. Use only genuine spare parts and accessories released and supplied by DOLMAR.
Use of non-approved accessories and tools means increased risk of accidents.
DOLMAR will not accept any liability for accidents or damage caused by the use of non-approved cutting tools and fixing devices of cutting tools,
or accessories.
First Aid
In case of accident make sure that a first-aid box is available in the vicinity of
the cutting operations. Immediately replace any item taken from the first aid
box.
When asking for help, please give the following information:
– Place of accident
– What happened
– Number of injured persons
– Kind of injuries
– Your name
Packaging
The DOLMAR Brush cutter or Grass trimmer will be delivered in two protective
cardboard boxes to prevent transport damage. Cardboard is a basic raw
material and is therefore consequently reusable or suitable for recycling (waste
paper recycling).
Brush Cutter / Grass Trimmer: model MS-20U, MS-20C (See TECHNICAL DATA for the specifications)
We declare under our sole responsibility that this product is in compliance with the following Directives, 2000/14/EC, 2006/42/EC.
The most important standards applied to properly meet the requirements of the above Directives were: EN11806.
Measured Sound Power: 108.5 dB
Guarantee Sound Power: 110.5 dB
These sound power levels were measured in accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex V.
Responsible Manufacturer:
Makita Corporation.
3-11-8,Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
DOLMAR Gmbh
Jenfelder Str. 38, 22045 Hamburg, Germany
EC-DECLARATION OF CONFORMITY
3rd. NOV. 2009
Tamiro Kishima
Managing Director
6
Rainer Bergfeld
Managing Director