Baby Unit Pairing; Quad Function - Luvion PLATINUM 2 Guide D'utilisation

14

BABY UNIT PAIRING

The system comes with a baby unit that has already been
paired with the parent unit. These units will communicate
with each other once they are switched on.
The pairing function gives each baby unit a seperate
channel on the parent unit (with a maximum of 4 baby
units) this is necessary for configuring additional baby
units.
Note: It is highly recommended to pair the baby units to
the parent unit before permanently mounting them.
1. Switch the baby unit on.
2. Switch the parent unit on.
3. Press the MENU button on the parent unit. Navigate
to the Pairing menu using the
button to enter the Pairing menu.
4. Select a channel using the
accept the channel.
5. A message will be displayed on the parent unit screen.
The parent unit will count down from 30 to 0. You have to
(shortly) press the Pair button on the baby unit within this
time to successfully pair it to the parent unit.
If the Pair button on the back of the baby unit is not
pressed within this time, the units will not be paired.
When the baby and parent unit have been paired, the
video from the baby unit will be directly displayed on the
screen of the parent unit.

QUAD FUNCTION

The system comes with a quad function. This function
enables you to watch the video from 4 cameras at the
same time. When the quad function is used the sound is
switched off. Press the quad button to switch to the quad
mode.
All manuals and user guides at all-guides.com
buttons. Press the OK
buttons. Press OK to
1 2
3 4