IME Nemo D4-Le Mode D'emploi page 38

Nemo D4-Le
Display
Display is divided into four menus, accessible with their relevant function keys:
The quantities and the display modes vary according to the selected connection (3-phase 3- or 4-wire line, single phase, etc.
In the following pages you could find all the displayed measurements based on the selected connection.
Acting on the function keys it is possible to scroll the different available measurements:
Phase voltage
Interlinked voltage
Min. voltage value
Max. voltage value
Voltage harmonic distortion
Voltage harmonic analysis
Voltage peak factor
Phase angle between the voltages
Configuration data*
*See configutation data display at page 24
Alarm Diplay
If the meter has been programmed for
Pressing any of the front keys, the display stops blinking.
When the alarm is intervened, press several times
14
Phase current
Neutral current
Current demand
Max. Current demand
Current harmonic distortion
Current harmonic analysis
Current peak factor
Phase angle between the currents
Configuration data*
relay output = alarm function
(see point 1.7)
key, until you display the alarm. page.
Quantity associated with the alarm
Alarm type (min/max)
Active power
Reactive power
Apparent power
Distorting power
Power demand
Max. Power demand
Configuration data*
, in case of alarm intervention, the display blinks in order to detect the anomaly.
Active energy
Reactive energy
Power factor
Voltage-current phase angle
Frequency
Run hour meter
Pulse counting 2 inputs
Configuration data*
07/18 E07 10782956 WEB E cod.MFD44..