CLAS DM 1522 Mode D'emploi page 20

DM 1522
AUTOMATIC TIRE CHANGER 10"-24" 1 SPEED SYSTEM 220V
Mounting the tyre
Note: Make sure that the size of the rim and the tire is the same before
mounting.
Clamp the rim on the turntable
Grease both side of the tyre and rim.
Place the demount head (4) on the edge of the rim, and move the air valve
aim at the mount/demount head.(Fig. 17)
Place one side of the tyre on the upside of the tail of the mount/demount
head (4), then press the other side of the tyre under the mount/demount
head (4), to make the tyre enter the groove of the rim. (Fig. 18) Pressing the
pedal (8) to turn the turntable clockwise, and complete mount the bottom
part of the tyre on the rim.
Repeat the above steps to mount the upper bead.
Note: It is not necessary to rotate the locking handle or loose the vertical
arm every time, if the size of the rims is the same, just step the pedal to tilt
backward the post (avoiding the aging of the locking valve).
Do not put your hand between the tyre and clamps and never stand behind the machine, avoiding
body injury.
Never adjust the pressure control valve inside the machine, otherwise the locking valve might be
damaged.