CLAS DM 1522 Mode D'emploi page 16

DM 1522
AUTOMATIC TIRE CHANGER 10"-24" 1 SPEED SYSTEM 220V
If the voltage is not stable r, a voltage stabilize should be connected between the power source
and the machine.
The machine should be well earthed .An automatic air-switch should be adopted with the main
power supply.
The power voltage only would change +10%.
Note: If there is no power plug on the machine, the user should mount on one, which suitable for
the electric current over 16A or connect the power supply directly according to the above demand.
For the machine with the motor of 3PH, step the pedal (8) after the connection of the power
supply and the turntable (V) should turn in a clockwise direction. If the turntable turn in the
counterclockwise position, reverse any two of the wires in the three-phase plug, the damage
caused by the ignorance of the above instruction, will not be covered by the manufacturer.
Connect the air hose of the air compressor with the tie-in of the separator.
The operating pressure of this machine should be 8-10bar (110-140Psi), the machine can work well
within such operating
pressure, if it is lower than 8bar(110Psi) the strength for the grip and bead break for turntable will
be not enough for some kind of tyres and even it can not operate the tyres.
Check if the reading on the pressure gauge that locates on the separator meet the demand of
pressure setting reading, if not so, check if there is some problems on the hose or air-compressor.
WARNING
• Never place leg between the bead breaker blade and bead breaker rubber, so as to avoid stepping
the wrong pedal and injury the operator.
• Never place hand on the tyre when the demount head is on the working position, so as to avoid
the injury of the operator.
• Never place your hand between the tyre and gripping device when operate the rim, so as to
avoid the injury of the operator.
• The jaws should be in closed position when do the bead break, so as to avoid the injury of the
operator.
• The operator should wear the protection glasses when inflate the tyres with the machine with GT
system, so as to avoid something blow into the eyes.
• Never put the hand between the rim and tyre when inflate the tyre, so as to avoid the injury of
the operator.
• There should be nobody behind the tilting post, when the machine is on the working position.