CLAS DM 1522 Mode D'emploi page 17

DM 1522
AUTOMATIC TIRE CHANGER 10"-24" 1 SPEED SYSTEM 220V
OPERATING TEST
Check the four pedals are in their original position; connect the air source, the operation can begin
when the pressure up to 8--10bar
Note: After the connection with the air source the clamp (5) on the turntable (6) should automatic
open, which is setted before delivery.
Pressing the pedal (8), the turntable (6) will turn in the clockwise direction.
Raising the pedal (8): the turntable (6) will turn in the counterclockwise direction.
Pressing the pedal (10), the bead breaker blade (22) will begin to move, when the pedal is released
the bead breaker blade returns to its original position. In the meantime please check towards the
body to see if the air regulator works well. Normally it will drop one drop of oil after the pedal is
pressed for 5-6 times, if it drops too quick or too slow, please adjust the index on the air regulator
by a screwdriver.
Pressing the pedal (9), the clamps (5) on the turntable (6) close; (when lightly step the pedal the
machine can show the step moving function). When the pedal is pressed again, the clamps (5)
open.
Press the pneumatic locking button (2), to lock the horizontal arm and vertical arm.
Pressing the pedal (11), the post will tilt back slowly, when the pedal is pressed again, the post will
return to its original position.
Notes:
• The machine must be fixed well to avoid the shake during the operation.
• The machine must place on the ground completely.
• Cut off the air and electric power sources before any maintenance.
• Check the screws on every parts of the machine is tight.
• Keep the human body and hands away from the moving parts of the machine during the
operation. The necklace, bracelet, loose clothes and long hair is dangerous for the operators. The
operator should wear safe clothes such as gloves and glasses.
• Keep the working area tidy and clean, or it may cause sudden accident
• The working area should be well lighted.