CLAS DM 1522 Mode D'emploi page 19

DM 1522
AUTOMATIC TIRE CHANGER 10"-24" 1 SPEED SYSTEM 220V
Inside locking
Pressing the pedal (9) make the 4-clamps closed to the position in accordance with the rim, then
put the tyre on the turntable, release the pedal (9) (release lightly), till the rim locked well.
Press the pedal (8) to turn the turntable (6), dip the prepared lubricator with the brush and
then lubricate the bead while turning,it is easy to damage the bead if do not follow the above
instructions.
Move the vertical arm in the working position, make the mount/demount head close to the bead,
the distance between the mounting head and the rim should be 4-5mm.(Fig. 11), then lock the arm
by press the locking button.
Note: The mount/demount head with good stiffness is made of special material and it has been
adjusted before delivery in accordance with the standard rim.
It is not necessary to adjust the angle when it operate the rim
from10" to 18", but if the rim is less or bigger than 10" to 18"
then it needs to be adjusted.
Note: In the event of a blockage, stop the machine immediately
and lift the jaw spreader pedal to rotate the platen
counterclockwise and unblock the machine.
If there is tube inside bead, take out the tube at first. Then turn
over the wheel to demount the other side of the tyre.
Insert the lever to lift the bead on the mount/demount head
(Fig. 15), step the pedal (9) to
turn the turntable clockwise,then
demount the tyre.
After demount the bead, please
clean the rim free from the rust
or oxide, and lubricate both sides
of the bead. (Fig. 16)