Nuna zaaz Mode D'emploi page 7

assemble footrest onto Seat
1 Slide down the lock behind the flap and lift the flap completely.
The seat automatically rises up to its highest position.
2 Attach the footrest on one side of the flap and then flex the footrest
to attach it on the other side.
3 Lower the flap down into position. Listen for the click as the lock
clicks back into position.
assemble Seat Cushion onto Seat
1 First remove the harness restraint if necessary, then place the seat
cushion onto the seat.
2 Insert the seat cushion clip into the inner of two holes in the sitting
surface of the seat and listen for a click.
assemble Harness restraint onto Seat
WARNING
When used as a high chair, the child must always wear
the harness restraint correctly fitted and adjusted.
1 Insert waist clips into the lower backrest holes (around the seat
cushion, when cushion in use) and listen for a click.
2 Insert shoulder harness clips into the upper backrest holes and listen for
( 5 )
click.
3 Insert the remaining crotch clip (through the seat cushion, when
cushion in use) into the inner of two holes in the sitting surface of the
( 5 )
seat and listen for a click.
4 Check that the harness attachment is secure by pulling on each
attachment point.
10
( 2 )
( 4 )
( 5 )
assemble arm Bar onto Seat
WARNING
The Arm bar alone DOES NOT guarantee the restraint of
your child!
1 Hook the ends of the arm bar into the holes in the backrest of the seat
(through the seat cushion, when cushion in use).
2 Click the front part of the arm bar into the outer of two holes in the
sitting surface of the seat (through the seat cushion, when cushion
( 7 )
in use).
3 Check that the arm bar is secure by pulling up on the front of the
arm bar.
assemble tray onto arm Bar
WARNING
The tray and the arm bar alone DO NOT guarantee the
restraint of your child!
1 Position the tray over the arm bar. Insert the tabs at the back of the
tray into the slots between the arm bar and the backrest of the seat,
( 8 )
as illustrated.
2 Push the tray down until the side clips fasten around the arm bar.
3 Check that the tray is secure by pulling up on the front of the tray.
( 6 )
( 9 )
11