Juniper NETSCREEN-ISG 2000 Mode D'emploi page 43

Chapter 4
Servicing the Device
This chapter describes service and maintenance procedures for your NetScreen-ISG 2000.
Topics in this chapter include:
• "Removing and Inserting Interface Modules" on page 38
–
–
• "Installing Power Supplies" on page 40
–
–
–
• "Replacing the Fan Module" on page 42
–
• "Connecting and Disconnecting Gigabit Ethernet Cables" on page 44
• "Removing and Installing a Mini-GBIC Transceiver" on page 45
Note: For safety warnings and instructions, please refer to the NetScreen Safety Guide.
The instructions in this guide warn you about situations that could cause bodily injury.
Before working on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents.
NetScreen-ISG 2000
"Removing Interface Modules" on page 38
"Inserting Interface Modules" on page 39
"Wiring the DC Power Supplies" on page 40
"Replacing a DC Power Supply" on page 41
"Replacing an AC Power Supply" on page 41
"Replacing the Fan Tray Filter" on page 43
4
37