Juniper NETSCREEN-ISG 2000 Mode D'emploi page 42

Chapter 3 Configuring the Device
3. Press the y key.
The following message appears:
!! Reconfirm Lost Password Reset !! If you continue, the entire configuration of
the device will be erased. In addition, a permanent counter will be incremented to
signify that this device has been reset. This is your last chance to cancel this
command. If you proceed, the device will return to factory default configuration,
which is: System IP: 192.168.1.1; username: netscreen; password: netscreen.
Would you like to continue? y/[n]
4. Press the y key to reset the device.
You can now login in using netscreen as the default admin name and password.
36 User's Guide