The Netscreen-Isg 2000 Interfaces; Configurable Interfaces; The Ethernet Interfaces - Juniper NETSCREEN-ISG 2000 Mode D'emploi

T N S
HE ET CREEN
The NetScreen-ISG 2000 provides physical ports, each of which can serve as a physical
interface. In addition, you can configure Ethernet ports to serve as virtual (logical)
interfaces.

Configurable Interfaces

The interfaces available on the NetScreen-ISG 2000 are as follows:
Interface Type
Ethernet interfaces
Layer-2 interfaces
Tunnel interfaces
Function interfaces

The Ethernet Interfaces

The ethernet interfaces are located on the interface modules (see
page 6). The interface names are as follows:
ethernet1/1
ethernet2/1
NetScreen-ISG 2000
-ISG 2000 I
NTERFACES
Description
ethernetn1/n2 specifies a physical Ethernet interface, denoted by an
interface module in a slot (n1) and a physical port (n2) on the module.
ethernetn1/n2.n3 specifies a logical interface, denoted by an interface
module in a slot (n1), a physical port (n2) on the module, and a logical
interface number ( .n3). You create logical interfaces using the set interface
command.
vlan1 specifies the interface used for VPNs while the NetScreen device is in
Transparent mode.
tunnel.n specifies a tunnel interface. Use this interface for VPN traffic.
mgt specifies an interface bound to the MGT zone. The default IP address of
this interface is 192.168.1.1.
ethernet1/2
ethernet2/2

The NetScreen-ISG 2000 Interfaces

ethernet3/8
ethernet3/1 . . . . . .
ethernet4/1 ethernet4/2
"Interface Modules" on
23