Rear-And-Front Mount - Juniper NETSCREEN-ISG 2000 Mode D'emploi

Rear-and-Front Mount

To mount the NetScreen-ISG 2000 with support from the rear and front, use the rear slide
mount kit.
1. Screw the left and right plates to the front of each side of the
NetScreen-ISG 2000 chassis.
2. Screw the rear mount bracket to the rear rack posts.
3. With the indented groove that runs the length of each slide facing outward,
screw the slides to the middle of each side of the NetScreen-ISG 2000 chassis.
Note:
along the length of the sides or extend them over the rear of the chassis.
4. Slip the slides into the rear mount brackets.
5. Push the NetScreen-ISG 2000 forward until the left and right plates contact the
front rack posts.
6. Screw the left and right plates to the rack.
NetScreen-ISG 2000
Depending on the depth of your equipment rack, you can attach the slides
Equipment Rack Mounting
17