Publicité
Les langues disponibles
Les langues disponibles
blade 10 cuts the workpiece through� Caution: use
only short saw blades 10 for this method of opera-
tion.
• Press support plate 1 and end of the saw blade 10
against the workpiece as shown on the figure 4.1.
Switch the power tool on� Lifting the back part of the
power tool gently, dip the saw blade 10 in the blank
slowly�
• Once the saw blade 10 cuts through the blank part
return the power tool into its normal operating position
and continue cutting along the marked line�
Wall surface flush sawing (see fig. 5)
• Use of the flexible bimetallic saw blades 10 enables
cutting of prominent parts of the structure (e�g�, brack-
ets, reinforcement bars, pipes) flush to the wall sur-
face�
• Press the end of the saw blade 10 to the wall (the
saw blade 10 must tightly adjoin to the wall in the cut
point, see fig. 5.1) and cut off the projecting piece of
the structure� Apply permanent side pressure to the
power tool, this will prevent jamming of the cutting
blade 10 and the overload of the tool motor�
Caution: make sure that the saw blade 10
is always longer than the diameter of the
processed item (see fig. 5.2), otherwise
there is a possibility of kickback and a
risk the saw blade 10 to be broken.
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
The manufacturer reserves the possibility to introduce changes.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 6�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
•
Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Recycle
disposing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
19
Transportation
of the power tools
Environmental
protection
raw
materials
instead
of
Publicité
