DWT SAS10-25 V Notice Originale page 17

Symbol
power tool designation
The sabre saw is designed for cutting wooden, plastic
and metal workpieces� Special saw blades extend sig-
Meaning
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Prohibited�
Double insulation / protec-
tion class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Wear protective gloves�
Stepless speed control�
Do not dispose of the power
tool in a domestic waste
container�
DWT
nificantly the application range of the power tool and
allows for cutting various materials, curved sawing,
flush cutting, deep cutting, etc.
1 Support plate
2 Saw holder
3 Fixing sleeve
4 Rod
5 Locking lever
6 Ventilation slots
7 Thumbwheel for stroke rate selection
8 On / off switch
9 Lock-on button
10 Saw blade *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
The inserting / replacing of the saw blade (see
fig. 1)
As a result of the long use the saw
blade 10 may become quite hot and
the sharp cutting edges may injure the
user, therefore one must always use
protective gloves when inserting / replacing the
saw blade 10.
• Turn the fixing sleeve 3 as shown on figure 1.1 and
keep it in this position;
• when installing the saw blade 10 - insert
saw blade 10 shank into the saw holder 2 (see
fig. 1.2).
• when removing the saw blade 10 - take out the
saw blade 10 from the saw holder 2� Warning: be-
fore removing the saw blade 10 make sure it has
cooled down enough after work.
• Release the fixing sleeve 3 (see fig. 1.3).
• Check tightness of the saw blade 10 by pulling it�
Warning: if fixed insecurely, saw blade 10 can
cause injures.
• The saw blade 10 is allowed to be installed with
teeth up - this may be required for specific kinds of
work�
Support plate (see fig. 2-3)
The support plate 1 facilitates work with the pow-
er tools, it provides perpendicularity of the saw
blade 10 towards the workpiece and also serves as
sawing stop allowing adapting to sawed material
position�
English
17
Power tool
components