Step 3: Installing The Feed Chute - DK2 POWER OPC524 Guide De Montage

STEP 3: INSTALLING THE FEED CHUTE

1. Install the feed chute on the two hinges. To seat the hinge pins for the first time, a rubber mallet
may be used to tap the pins into the hinges. These are tight fitting to reduce vibration noise.
Close the chute and latch it.
2.
3. Plug the safety shut off wire connectors together.
4. You can now use the chute by the handles to tip the unit back so you can perform the next step
and install the hitch.
8 | OPC524 man. v.210525
ASSEMBLY
STEP BY STEP INSTRUCTIONS