Publicité
Les langues disponibles
Les langues disponibles
PARTS INCLUDED
2 - Metal Grilles
1 - Trim Bracket
1 - Trim Seal
1 - Parts Bag (containing):
4 - No. 8 x 7/8" screws
INSTAL LAT ION
INSTR UCTI ONS
B Cut one 18¼" x 2½" (464 mm x 64 mm) OPENING
(A)* in the cabinet toe kick.
-- or --
Cut one 18¼" x 2½" (464 mm x 64 mm) OPENING
(B) in the cabinet side or back.
Mount one of the two metal grilles over this opening,
using two screws provided.
C
If you chose to cut an opening in the toe kick - you
must cut another 18¼" x 2½" (464 mm x 64 mm)
OPENING (C)* in the cabinet fl oor.
Mount the second metal grille over this opening.
* IMPORTANT NOTE
When using toe kick opening (A) with opening (C) in
cabinet fl oor: Air must be able to fl ow freely between
these two openings - and not restricted by cabinet
structure or any other obstruction.
D
Clean housing surface (B) with Isopropyl Alcohol or
Rubbing Alcohol. Remove TAPE STRIPS to reveal
adhesive side of tape from the back side of TRIM
BRACKET (A).
E Center trim bracket left-to-right at TOP OF
DOWNDRAFT HOUSING (B). Stick trim bracket to
downdraft housing so that FLANGES (C) and (D) are
fl ush with each other.
F Cut TRIM SEAL (E) to length: No shorter than
downdraft countertop cutout opening and no longer
than cooktop width.
G Remove tape backing from TRIM SEAL (E). Center
trim seal left-to-right and stick trim seal across both
FLANGES (C) and (D).
4
B
B
C
C
A
B
E
B
G
E
C
A
D
B
B
A
D
F
Publicité
